|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
05-23-2014, 03:28 PM
|
#1 |
|
Gone Wild
 Join Date: Sep 2013
Location: Spartanburg, SC
Posts: 291
|
Alltrax program voltage lower than DVM
The voltage on the controller programmer shows 48.9 volts whereas the DVM shows 51.5. Should there be this much difference in pack voltage and voltage at the controller?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-23-2014, 03:30 PM
|
#2 |
|
Gone Wild
Join Date: Jul 2013
Location: kansas city, mo
Posts: 323
|
Re: Alltrax program voltage lower than DVM
yes, I noticed this too with my 48400. I don't know why it that much different.
|
|
|
|
|
05-24-2014, 09:20 AM
|
#3 |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Alltrax program voltage lower than DVM
It would depend on where they were measuring the voltage vs where you are measuring the voltage.
Looks like they only have two choices, between the B- and B+ terminals on the controller and between the B- and KSI terminals on the controller. Best way to find out is call or e-mail Alltrax. |
|
|
|
|
05-24-2014, 11:06 AM
|
#4 |
|
Voltaholic
Join Date: Dec 2013
Location: Close to Navasota Texas
Posts: 934
|
Re: Alltrax program voltage lower than DVM
I have been wondering what causes the difference too. My alltrax controller, cycle analyst and several multimeters all read slightly different. If you are not familiar with the cycle analyst it combines a speedometer, volt meter, ammeter, kilowatt meter, watt-hour per mile and a bunch more stuff.
They all read the amperage differently also. I have no idea which one to trust. |
|
|
|
|
05-24-2014, 12:27 PM
|
#5 |
|
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Alltrax program voltage lower than DVM
One possible answer, precharge resistor. Try checking the voltage going into (will match DVM) and out of (will match controller) the large terminals of the solenoid.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| How do I program my new Alltrax? | Electric Club Car | |||
| AllTrax AXE400 Stock Program | Electric EZGO | |||
| Alltrax program help | Electric Club Car | |||
| program an alltrax ? | Electric EZGO | |||
| program alltrax | Electric EZGO | |||
Linear Mode
