|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-17-2017, 06:55 AM | #1 |
Not Yet Wild
Join Date: Mar 2017
Posts: 4
|
Help! Need to separate G9 case
Recently picked up a 92' G9 that smoked like a train, have the engine out currently and am trying to split the case to get the piston out. Once it's out I can stick a bore gauge in and check to see what size piston and rings I need to up to. I'm currently at a point where I am unable to separate the crank case cover from the shaft. (I take it, it's pressed on) I'm not sure how I'm going to get a puller attached to remove it? Can I go in from the opposite side and remove the ... flywheel? (Not engine savvy)
Thanks ahead Eggie |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-17-2017, 04:48 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Help! Need to separate G9 case
Cover is not pressed on the crank. Bearing will remain in cover, crank will remain in block. You will not get any help from removing flywheel, because crank will still be trapped by its attachment to piston & rod.
|
03-17-2017, 04:56 PM | #3 |
Not Yet Wild
Join Date: Mar 2017
Posts: 4
|
Re: Help! Need to separate G9 case
That sucker is on there good then! I will give it another shot then this evening.
Thanks |
|
|
Similar Threads | ||||
Thread | Forum | |||
Separate Battery used for headlights | Electric Club Car | |||
Ruff & Tuff Transfer Case or Transmission Case Needed | Electric golf carts | |||
Use a voltage reducer or buy separate battery? | Electric Club Car | |||
Rear Seat Armrest Bar (Pic): Can one buy this separate? | Electric EZGO | |||
Does a 2pg have a crank case pressure pickup tube inside the crank case? (pic) | Gas EZGO |