No Fire at Plugs

[Shooting Jack]

My 98 Ezgo Txt 295 cart had been running but was hard to start at times but after parking overnight it would not start. Checked fire at plugs and no fire, replaced coil and ignitor and still no fire. Where is the Pulsar coil and how to check it? I've looked in a manual and don't see pulsar location. Thanks for the help.

[Spicyunicorn]

Testing the Pulser Coil
Unplug the connector leading into the engine. Place the
(-) probe from the DVOM (set to the ohms scale) on the
red/white wire from the pulser coil, and the (+) probe on
the black wire also from the pulser coil. A reading of
433.5 - 586.5 Ω should be observed. If the measure-
ment obtained is out of this range or if a reading of no
continuity is displayed, replace the pulser coil. Make
certain that the air gap is correct. Set with a .032” feeler
gauge. There is no timing adjustment.

[Spicyunicorn]

They wires will be on the fan side of the motor also do a votage test on it while spinning motor over it should be around .5 ac volt (I think) hopefully someone will chime in if I'm wrong

[Shooting Jack]

I got a zero reading with the ohm meter across the wires. Will check for voltage too.