G2 Primary clutch puller needed

[gdflys]

I have a G2 motor out of our cart and need to get the fixed sheave removed for engine rebuild. Does anyone have a Yamaha G2 G9 clutch puller tool they would be willing to loan me? I'll pay for shipping both ways with a little extra for your trouble. It will still be cheaper than the $60 Yamaha wants and less hassle than fabbing one up myself.

Thanks,
Greg

[1989Marathon]

Stock clutch? If so, do a search on this forum for clutch puller. You just need a bolt and a piece of rod for a spacer. I believe the bolt thread is 3/4-16

[bigstik40]

NOTE - The correct thread for the clutch puller is 14mm dia. x 1mm pitch and is a very difficult bolt to find in stock anywhere. (I tried) Unfortunately, making your own puller is not a good option in the case of the Yamaha engine because of the odd thread. There also have been some posts here suggesting to use a spark plug for the bolt, but unfortunately that thread at 14 mm has a pitch of 1.25 mm and will not work.
Good luck - RAY

[1989Marathon]

Thanks for the clarification. It's been a while since I pulled a yamaha clutch.

[bigstik40]

No problem!! This came up on a thread recently so it was fresh in my mind. RAY

TO GDFLYS: I would let you borrow mine, but at the present time it is 1200 miles to the North of me (see signature). I will have access to it in about a month, but I'm sure you don't want to wait that long. - RAY

[gray horse]

Check e-bay, on there for approx $32.00.