|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
09-22-2011, 08:41 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2007
Posts: 45
|
Removing clutch on 2006 EZGO 4 cycle
My 2006 EZGO TXT with the 295 4 cycle has some front drive clutch noise, and I would like to remove the clutch to check it out. I don't have a clutch puller, but I have a hunch I can remove the clutch by removing the factory installed 7/16"-20 thread 6-1/2" long bolt...useing a 3/8" dia round stock about 6" long into the hole the 7/16"-20 bolt was, and using a 7/16" -20 thread bolt about 1-1/2' long to thread into the hole to pull the clutch off the engine shaft.
Has anyone done this with such bolts and not a clutch puller? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-23-2011, 08:34 AM
|
#2 |
|
Gone Wild
Join Date: Aug 2008
Location: Georgia
Posts: 232
|
Re: Removing clutch on 2006 EZGO 4 cycle
I don't know about all the sies you listed, but thats the way I did it. Take the bolt out, put a round stock bar in and another bolt and it's just like what a purchased puller would be like.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Help removing driven clutch | Gas EZGO | |||
| Removing 06 Precedent clutch | Gas Club Car | |||
| Removing Clutch on G29 | Gas Yamaha | |||
| Removing the clutch | Gas Club Car | |||
| Removing an EZGO clutch | Ezgo Gas Tech | |||
Linear Mode
