|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-22-2012, 12:41 PM | #1 |
Not Yet Wild
Join Date: Nov 2012
Posts: 13
|
getting closer but still need help
87 Easy go believe it is a 2pg motor. Lost spark, got spark back with HEI conversion. HEI module said it was for a 85 K5 Blazer, dont know if that makes a differance. Still have the stock coil. Put the cart on jack stands, cracked the tail pipe from the muffler and got the rpms to ramp up pretty good.
On the ground with me in it, backsfires like crazy with the tail pipe cracked but did run better with open exhaust. Runs better in reverse then forward. Tried the WD40 trick on the crackseal and that did not help. I did buy this cart in Phoenix Arizona and now it is in a town that is 6000 ft higher in elevation, does it need to be re-jetted? Also runs better or worse in differant positions of the forward and reverse switch. Any help or advice would be appreciated. Thank you. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-18-2013, 05:11 PM | #2 |
Not Yet Wild
Join Date: Nov 2012
Posts: 13
|
Re: getting closer but still need help
Help still very sluggish....
|
03-18-2013, 06:09 PM | #3 |
Gone Wild
Join Date: Aug 2011
Location: Central Delaware
Posts: 859
|
Re: getting closer but still need help
To answer your jetting question; yes, probably. But you'll get a lot more and possibly better responses in the Gas EZGO section.
|
03-20-2013, 06:12 PM | #4 |
Not Yet Wild
Join Date: Nov 2012
Posts: 13
|
Re: getting closer but still need help
ya i seen that..not sure how to move thread
|
03-20-2013, 06:56 PM | #5 |
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: getting closer but still need help
|
03-20-2013, 07:02 PM | #6 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: getting closer but still need help
Have you swapped the red and blue wires going into the hei module? The pic you posted is how the drawing is shown. Usually they need to be reversed to get the correct timing.
|
03-25-2013, 02:58 PM | #7 |
Not Yet Wild
Join Date: Nov 2012
Posts: 13
|
Re: getting closer but still need help
I tried that and it ran worse...
|
03-25-2013, 06:01 PM | #8 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: getting closer but still need help
Are you sure it's getting enough fuel?
|
03-25-2013, 11:57 PM | #9 |
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: getting closer but still need help
Humm? I think I would try replacing the plug wire and a new plug and see if you get any change not a big cost and your not out anything if that's not it.
LOU |
|
|
Similar Threads | ||||
Thread | Forum | |||
getting closer | Gas Yamaha | |||
getting closer, but need Vacuum line help,, | Gas Yamaha | |||
getting closer to finishing | Lifted Golf Carts | |||
One step closer | Lifted Golf Carts | |||
95 Ezgoes it.... getting closer.... | Lifted Golf Carts |