Speed sensor for 2003 ezgo pds cart

[moobun]

2003 ezgo pds cart quit me last fall. Fault code told me motor was bad, so removed it and bench tested and it was bad. Cart set for 2 months before i found a new motor and put it in. When installing it, it had no receptacle for the speed sensor magnet, had 3 wires on the end of motor. Cut magnet off speed sensor cable and wired it in. Cart still won't run, just clicks solenoid. Pack checks 37.5 v so batteries shoulb be ok. Any ideas??

[JohnnieB]

37.5V is only 80% SoC, so the batteries should be fully charged (38.2V) to prevent the plates from sulfating more than they already are.

A PDS cart will run (very reduced performance) without the speed sensor connected, so the motor you have might not be compatible with a PDS controller.

What are manufacturer and model# and/or Part# on motor label?

What fault codes are you getting now?

[moobun]

Motor is admiral mot-b2, does not give ma fault code now. Also pack voltage is down to 36.2 after 24 hrs, have a drain somewhere.

[scottyb]

That is a PDS motor.

[moobun]

My cart is pds