|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
07-08-2015, 08:36 AM
|
#1 |
|
Gone Wild
 Join Date: Jan 2009
Location: North Topsail Beach, NC
Posts: 231
|
2010 TXT question....
OK guys...This is a 48 volt 2010 TXT ezgo....This cart was in an accident when being towed, and the only damage was the top was bent...The cart did not turn over...The problem came when someone tried to steal the cart when the driver went to get a hub and tire...The cart was towed about a mile with the tow/run switch in the run position...
The cart ran fine prior to this incident. Now the solenoid is not clicking....Now my first thought is the controller is burnt from being towed...However, while checking the solenoid, I have 50 volts on all four post...so I start to disconnect wires to check continuity on the solenoid... End results, with all the wires disconnect from solenoid, I have 50 volts on the cable coming from the controller to the solenoid....I believe it should be the other way...50 volts on battery side then the clicking of the solenoid sends 50 volts to the controller... OK...I have the download on how to check the controller, just trying to save a little time.... Is the controller bad (100%) if it is sending volts to the solenoid... Thanks...Bill |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-08-2015, 08:56 AM
|
#2 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2010 TXT question....
No - you are reading the capacitor charge in the control. But yes, it is most likely the control and possibly the motor are bad after being towed in run.
|
|
|
|
|
07-08-2015, 09:08 AM
|
#3 |
|
Gone Wild
Join Date: Jan 2009
Location: North Topsail Beach, NC
Posts: 231
|
Re: 2010 TXT question....
Thanks Scottyb.....OK...I will do the continuity test on the motor and guess I will go ahead do the controller test....Its going to be a pain in the butt on the 2010, the controller is mounted upside down and the wires are really short...
Thanks Bill |
|
|
|
|
07-08-2015, 09:33 AM
|
#4 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2010 TXT question....
Ok, post the model # on this control when you can.
|
|
|
|
|
07-08-2015, 01:42 PM
|
#5 |
|
Gone Wild
Join Date: Jan 2009
Location: North Topsail Beach, NC
Posts: 231
|
Re: 2010 TXT question....
Scottyb...Its a Curtis model 1206HB-5201 48 volt
How long will the compositor hold that charge.... You have something else in mind don't you.....ok...what is it. |
|
|
|
|
07-09-2015, 07:42 AM
|
#6 |
|
Gone Wild
Join Date: Jan 2009
Location: North Topsail Beach, NC
Posts: 231
|
Re: 2010 TXT question....
Scottyb....I will start to test the controller on this one this evening....Did you come up with any easier way to test it....
|
|
|
|
|
07-09-2015, 09:46 AM
|
#7 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2010 TXT question....
This is a TXT48 sepex drive system. With the precharge resistor removed the controller should bleed off the caps in 15 minutes or less for safety (typical)
|
|
|
|
|
07-12-2015, 10:22 AM
|
#8 |
|
Gone Wild
Join Date: Jan 2009
Location: North Topsail Beach, NC
Posts: 231
|
Re: 2010 TXT question....
Update...solenoid bad....waiting for new one....
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 2010 with 14" question? | Electric Club Car | |||
| Lifted 2010 EZGO RXV Question | Lifted Golf Carts | |||
| 2010 RXV Electric question | Electric EZGO | |||
| 2010 txt brake question | Electric EZGO | |||
| 2010 club car question | Electric Club Car | |||
Linear Mode
