07-08-2017, 11:32 AM | #1 |
Not Yet Wild
Join Date: Jul 2016
Posts: 6
|
no power
i have 2000 workhorse that has no power new fuel pump filter and carb new belt and driven clutch, cleaned and lubed drive clutch. coil oms ok as does pulsar coil fuel pump is after market flow showed just opposite as old so plumbed with arrows on new seems to push gas ok problem was intermittent at first now wont go away
thanks george |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-08-2017, 11:42 AM | #2 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,495
|
Re: no power
The first thing to do is set the valve clearance to .004". Lots of threads here on specific instructions.
|
07-08-2017, 12:03 PM | #3 |
Not Yet Wild
Join Date: Jul 2016
Posts: 6
|
Re: no power
i checked valve clearnce old carb had what looked like some type of sediment in it that was hard had to knock it loose used carb cleaner reinstalled same condition
|
07-09-2017, 03:37 PM | #4 |
Not Yet Wild
Join Date: Jul 2016
Posts: 6
|
Re: no power
any more suggestions
driven clutch was badly worn on inside of ramps the fiber slides where worn past the screw heads |
07-10-2017, 03:23 PM | #5 |
Not Yet Wild
Join Date: Jul 2016
Posts: 6
|
Re: no power
is there any way to check ignitor
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G1 not starting...no power power coming from magneto? | Gas Yamaha | |||
Full power in reverse, part power in forward | Electric EZGO | |||
2005 Precedent starts of powered, then loses power, reverse always power | Electric Club Car | |||
Power Wise Charger worked after board replaced now back to no power | Electric EZGO | |||
have power on ezgo buggy no power light | Electric EZGO |