09-05-2018, 03:21 PM | #1 |
Getting Wild
Join Date: Jul 2013
Posts: 102
|
Solenoid ?
Ok tried to jump the Solenoid.. from the side post to the red positive side and it shot fire out like crazy.. what did I do wrong.. I have done this is the past.. is something hooked up wrong.. shldnt I be able to put 36 volts to the small red terminal.. and the resistor have the strip to the positive side please help
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-05-2018, 05:03 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: Solenoid ?
Can you post a picture of the solenoid showing the posts you made fire with
|
09-06-2018, 10:39 AM | #3 |
Getting Wild
Join Date: Jul 2013
Posts: 102
|
Re: Solenoid ?
Not sure how to load pics
|
09-06-2018, 10:45 AM | #4 |
Getting Wild
Join Date: Jul 2013
Posts: 102
|
Re: Solenoid ?
Ok why do I have 36 volts and all 4 terminals now.. wth
|
09-06-2018, 10:46 AM | #5 |
Getting Wild
Join Date: Jul 2013
Posts: 102
|
Re: Solenoid ?
Is this a ground issue shldnt the black side of the solenoid be ground?
|
09-06-2018, 11:33 AM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Solenoid ?
Also, what model cart. Please say you didn't try this with a Rxv.
|
09-06-2018, 12:42 PM | #7 |
Getting Wild
Join Date: Jul 2013
Posts: 102
|
Re: Solenoid ?
Txt.. DCS I believe
|
09-06-2018, 03:40 PM | #8 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: Solenoid ?
Remove the resistor board from the 2 small terminals or any pre-charge resistor or diode on the solenoid. With the key off you should have power (+) on one big post with the battery cable connected.
With the key on and the cart in gear you should have power at the one big post above and one or both of the small terminals. with the pedal partially depressed the small terminal without the red wire on it should change to (-) and the solenoid should CLICK bringing power (+) to the second big post. |
|
|
Similar Threads | ||||
Thread | Forum | |||
E-Z-GO RXV Solenoid - 48 Volt Solenoid to Replace 36 Volt Solenoid... | Electric EZGO | |||
96 club car ds solenoid wont click and cart wont move unless you jump solenoid | Electric Club Car | |||
Solenoid not engaging with Forward / Reverse switch? (Solenoid is good) | Electric EZGO | |||
EZ-GO Txt 48v with AXE - No solenoid Click - New Solenoid | Electric EZGO | |||
Help converting G1 solenoid setup to single G16 solenoid | Gas Yamaha |