|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-14-2020, 06:27 PM | #1 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
2001 e z go txt gas no spark
Hello all, i am having a big problem with an e z go txt robyn engine pre mci.i lost total fire, i have replaced coil, pulsar coil, igniter and solenoid. I will get a small spark at initial start up and it is gone after. Each time i hit the pedal it will spark once and that is it. Can someone please point me in the right direction please? Also the key switch test fine and the micro switch in the floor seems to be working just fine also.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-14-2020, 06:43 PM | #2 |
Gone Wild
Join Date: Mar 2019
Posts: 156
|
Re: 2001 e z go txt gas no spark
Here is your manual...http://products.jacobsen.com/img/manuals/605586.pdf
Section L is your wiring diagram. Put a test light on the positive and negative termianls of your ignition coil. You should have a flashing light when you turn the engine over with the starter. If it doesnt come on at all, trace that back to your solenoid. If its a solid light without flashing, trace it back to your igniter and go from there. It must be flashing to initiate spark. |
07-15-2020, 07:40 AM | #3 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
Re: 2001 e z go txt gas no spark
Ok I will try this, thank you
|
07-15-2020, 08:05 AM | #4 |
Not Yet Wild
Join Date: Nov 2013
Posts: 28
|
Re: 2001 e z go txt gas no spark
try a meter on the white wire on your ignition coil. with the engine turning you should have about 11.5v now try it on the red you should have very little. the test light should light up only on the white.
make sure that the 4 pin connector that comes from the igniter box is connected in the right way. This had me beat.The wires do not corispond on each side.the white should line up with the red.Hope this helps |
07-15-2020, 01:46 PM | #5 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
Re: 2001 e z go txt gas no spark
10.94 on white wire and 1.2 on red wire
|
07-15-2020, 01:57 PM | #6 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
Re: 2001 e z go txt gas no spark
[ all I get is a solid light, no flashing. I have tried 2 new igniters and still the same. Also the ground wire from igniter goes straight to battery
QUOTE=newtjl;1740452]Here is your manual...http://products.jacobsen.com/img/manuals/605586.pdf Section L is your wiring diagram. Put a test light on the positive and negative termianls of your ignition coil. You should have a flashing light when you turn the engine over with the starter. If it doesnt come on at all, trace that back to your solenoid. If its a solid light without flashing, trace it back to your igniter and go from there. It must be flashing to initiate spark.[/QUOTE] |
07-16-2020, 08:58 AM | #7 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
Re: 2001 e z go txt gas no spark
I had to take it to the shop. I could not find the issue. I have a huge farm with multiple carts and they all are breaking down right now. Always something
|
07-16-2020, 11:46 AM | #8 |
Not Yet Wild
Join Date: Aug 2019
Location: Zanesville, Indiana
Posts: 20
|
Re: 2001 e z go txt gas no spark
Are you referencing an aftermarket ignitor and 4 pin connector? My OEM ignitor and 4 pin connector has aligned white wires.
|
07-16-2020, 03:02 PM | #9 | |
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,215
|
Re: 2001 e z go txt gas no spark
Quote:
There is a red wire with white stripe and it does indeed go to connector from ignitor and come out as red with white stripe but the one we are talking about is solid red going in and white on other side of plastic connector heading to coil. This red with white stripe goes to pulser coil under flywheel along with the black wire. Also the plastic connector a few inches from ignitor will snap in place when you hit it right and the ones I have here at my shop cannot be plugged in incorrect. I have always wondered why the wiring diagram shows red from solenoid to coil when in fact they leave red and end up white, same wire by the way . I have a few OEM used ignitors and I own three carts with pre mci engines and they are all the way I said. I think I could wire one in my sleep as many as I have done. I am not sure why so many people have problems with the firing on these engines. Maybe because of ordering a part that was not bad to begin with. I can tell you these aftermarket ignitors are mostly junk and cause more problems that they help. |
|
07-23-2020, 09:00 PM | #10 |
Gone Wild
Join Date: Nov 2012
Posts: 334
|
Re: 2001 e z go txt gas no spark
Turned out that the new pulsar coil was bad. Made in china
|
|
|
Similar Threads | ||||
Thread | Forum | |||
No Spark EZGO 2001 Replaced All | Gas EZGO | |||
2001 Ezgo no spark | Gas EZGO | |||
2001 FE90 no spark | Gas Club Car | |||
2001 club car no spark | Gas Club Car | |||
2001 Gas ez-go TXT no spark | Gas EZGO |