Clutch recommendation

[BigLar368]

Well I got my new clutch and belt in. It took longer to pick up all my tools than it did to install everything back on. Upon driving the cart it is very jerky as the belt is really tight. When it's in gear you cant even push the cart because the belt grabs. I called and spoke with Tom and he says to drive the cart so the belt will "wear in" to the clutch since it's all new or just put the old belt back on. I already have about 15 miles on it but it's still doing he same thing. Take off and top speed are much improved over stock but the jerking at low speed and initial take off are horrible. Gonna try the old belt tomorrow and see it it makes a difference.

[swampsat]

the old belt may help some til the clutch breaks in good luck

[BigLar368]

Is it the sheaves that break in or is it something inside the clutch?

[HemiED]

Originally Posted by LURCH

Try Tom @ Cart Parts Plus he is a sponsor also 1-888-861-2640.

Exactly, that is where I bought a new one, plus a roller kit for my other one. He is a good guy and takes care of you.

http://www.cartpartsplus.com/

[HemiED]

Originally Posted by BigLar368

Well I went ahead and ordered this clutch and belt:

http://www.cartpartsplus.com/yamaha-...rf-clutch.html
http://www.cartpartsplus.com/severe-...rive-belt.html

Will post results when parts arrive and I install them. Thanks to those who helped.

OOps, late to the party, but glad you got it from Tom.

[BigLar368]

Well I put the old belt back on. It will roll in gear now basicly because it is not as wide as the new belt and its a bit longer. It starts at little better but still wont idle. The engine barely starts and the clutch starts moving in. Think I need to make the spring a little stiffer so it will not start moving under under such little idle.