|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-28-2010, 11:44 PM | #11 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
I think the higher voltage is jacking with the ITS ..... I wanna go back out to the shop and try it on 32v .......later
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-01-2010, 12:05 AM | #12 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
No change on 32 volts .... ??? What am I doing wrong? Cart had NO wire harness except 4 wire harness from peddle box.... white and black to controller throttle and green power to micro and red power back out to the micros... Here is the stock diagram & Here is my wiring diagram. ( in a minute) What a strange problem?
|
03-01-2010, 12:12 AM | #13 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
With any uploading luck here is my 48v adaptation .....
|
03-01-2010, 12:19 AM | #14 |
Gone Wild
Join Date: Dec 2009
Location: Gastonia NC
Posts: 530
|
Re: ITS questions
what is the controller putting out at white wire..? you should have 1.5 volts on one side of the its... when you press the pedal the votage should rise from 0 to 1.5 going to the controller...
|
03-01-2010, 12:22 AM | #15 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
I am not getting any reading?
|
03-01-2010, 12:26 AM | #16 |
Gone Wild
Join Date: Dec 2009
Location: Gastonia NC
Posts: 530
|
Re: ITS questions
controller is not getting the command to run from the switch or bad controller
|
03-01-2010, 12:29 AM | #17 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
2 controllers tried, both bench pre-programmed. 3 ITS units tried, 2 solenoids, New F&R, New Ignition.
I got a headache, now...... Good night ... you guys keep looking at this and tell me what I'm doing wrong, okay Thanks Remember cart runs SLOW |
03-01-2010, 09:28 AM | #18 |
Not Yet Wild
Join Date: Jun 2009
Posts: 35
|
Re: ITS questions
FWIW, my 05 TXT is an ITS system and the upgrade to 48 volts has not been any problem with the system thus far. Be happy to check measuring figures on it for a base you can compare your numbers against.
|
03-01-2010, 09:47 AM | #19 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: ITS questions
Thank you but I am at a loss for what to check?
|
03-01-2010, 11:17 AM | #20 |
Just one day at a time
Join Date: Sep 2009
Location: South TX
Posts: 8,650
|
Re: ITS questions
Scottyb
I did a similiar build but not 48v, but just asking, when I wired up mine the red wire from the ITS went to the solenoid and a seperate red wire to the controller from the solenoid, then of course black to pin 2 and white to pin 3. This is the only thing I see different in your drawing I am going to look at it again. Ok looked at drawing again, I jumped a wire in the drawing |
|
|
Similar Threads | ||||
Thread | Forum | |||
More Questions | Gas Club Car | |||
New Guy Questions | Electric EZGO | |||
few questions | Electric Club Car | |||
More questions | Gas EZGO | |||
oil questions | Gas EZGO |