05-22-2021, 04:18 PM | #1 |
Not Yet Wild
Join Date: May 2021
Posts: 2
|
Club Car XRT 950 belt?
I have a 2008 XRT 950 with the B&S Vanguard engine. It has about 980 hours on it and it got to where it would creep at idle, when in gear, with the brake off. It does it worse in reverse. Other than that the cart has been without issues. I tuned it up 4 years ago and I change the oil annually. I took the belt off and it is what looks like a HD belt in that has teeth on both sides. It is 43 inches in circumference and 1-5/16 wide. Also the distance center to center on the 2 pulleys is right at 11 inches. The pulleys look to be in good shape other than a little scarring on the edge of the rear pulley, probably from belt removal/install.
Is this belt a factory-spec one? Where can I find a replacement? TIA!!! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-23-2021, 10:39 AM | #2 |
Not Yet Wild
Join Date: May 2021
Posts: 2
|
Re: Club Car XRT 950 belt?
A little more detail. The 1-5/16 measurement is from the outside of the belt. The inside is 1-3/16 and the circumference is closer to 42 inches. I have a part number from the CC book of 103416101, but I can't get any specs of that part # to confirm it meets the measurements I have. Can anyone offer any info? Thanks!!
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
97 Club car belt slipping | Gas Club Car | |||
94 club car belt too short | Gas Club Car | |||
club car drive belt | Gas Club Car | |||
club cas gas drive belt | Gas Club Car | |||
Shorter Belt For Gas Club Car | Lifted Golf Carts |