|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-05-2016, 11:29 AM | #1 |
Not Yet Wild
Join Date: Sep 2016
Posts: 7
|
2000 PDS EZGO possible speed sensor or controller problems
Here is the situtation. Old engine burnt up.
Got new batteries now New D&D motor high torque Motor came with triangular connector Old engine had flat connector with red white black wires, wired new motor to red whit green wire..cart runs a few feet then just goes to a crawl...flip tow switch and it pulls off hard again then goes limp. Could it be speed sensor..has any one tried this wiring before with success? Thanks for any responces. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-05-2016, 02:39 PM | #2 |
Not Yet Wild
Join Date: Sep 2016
Posts: 7
|
Re: 2000 PDS EZGO possible speed sensor or controller problems
Ok..that's correct..I do have that.
Diag mode says select run mode..then toggle back and forth between neutral and reverse 5 times....???? Then what it doesn't give instructions after that.... Thanks for the tutoring really appreciate it. |
|
|
Similar Threads | ||||
Thread | Forum | |||
MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
speed sensor, controller or both? | Electric Club Car | |||
PDS speed sensor problems | Electric EZGO | |||
New speed sensor and still problems | Electric Club Car | |||
Cart Problems: Speed Sensor & Motor Stall | Electric Club Car |