EZGO Rivet List

[SCfan]

Need to put the locations with the pic numbers. Can anyone confirm below rivet locations are correct? Btw #1 is actually 3/16x5/8 - 11/16 grip




#3

#2 ?

#1 ?

#5 ?

[kgsc]

Go read post 38

#1 are for the seat hinges and lower front cowl
#2 are for the rear body front floor and between the hinges.
#3 are lower sides of the body
#4 are for the top of the cowl/dash
#5 are for the side scuff plates
#6 are for the floor of the bag well

Looks like you’re missing the rear bumper cover.

[Capt. Lenny]

Originally Posted by LostHusker

Well since I have two carts now apart, I felt I needed to look up some information, since I had it I felt it was necessary to share this will everyone else. I would think that someone else could use this information as well. If I have missed something on the list let me know and I will add it to the list accordingly, but I think I have gotten most of it. Hope this helps someone.

This is a list of Rivets needed if doing a complete frame break down. I pulled this information from Service Parts Manual starting 2003. Some/Most of these parts will also work on older EZGO models back to 1994, to the Medalist. There are some parts that are different, please refer to your cart to make sure. The Front Cowl Rivels are expandable (Molley Type)



1. Body Front
Dash area 3/16” x 1” Aluminum x 9
Vinyl Trim sides that hold mat down and bottom of dash 3/16” x 1” AL x 10
Bottom of Front Cowl 3/16” x ¾” Stainless x 2
Front Shock Cover ¼” x 1” x 2
Key Switch Plate, it was not listed, but a set of screws will work.


2. Body Mid-Section Floor Pan and Fire Wall Area
Rivet 3/16” x 9/16” x 16
Rear fender area ¼” x ¾” LG x 8


3. Body Rear
Seat Hinge 3/16” x ¾” Stainless x 4
Bag Well ¼” x ¾” x 2
Rear Bumper 3/16” x 9/16” Aluminum x 4
Bottom of Rear Body Rocker Panel area ¼” x 9/16” Aluminum x 4
Rocker Panels 3/16” x 15/16” x 4
Front of Rear Body Floor Pan Area 5/32” x 9/16” x 6
Horn Button if equipped Rivet 3/16” x 1” LG x 2
Charger Receptacle 3/16” x 1” Aluminum x 4

I don't know why this isn't in the stickies but thought it would be worth posting up again. Now all I have to find out is if anyone seels a whole kit. Would rather not have to buy them individually.

[TheNewGuy]

Sticky!

[scottyb]

Originally Posted by TheNewGuy

Sticky!

Awesome - Thank you TNG and Mark. What a nice contribution to the forum.

[Ezpz1001]

Do you need these sizes exactly? Does aluminum v stainless steel really matter?

[LukeL]

There are kits available from most dealers and online. Check with the site sponsors first- if they don’t sell the kit Amazon does.