|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
01-24-2010, 06:34 PM | #1 |
Getting Wild
Join Date: Aug 2009
Posts: 89
|
Just got a G9 need to know how to wire ignition switch to push pull switch ASAP!
I got the cart today need to replace switch but the guy removed the old one I wanna just put a push pull switch in butits only two prong what wires go where? there is a solid red a black with red stripe brown and black someone help
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-24-2010, 07:21 PM | #2 |
Not Yet Wild
Join Date: Jan 2010
Location: Port A, TX
Posts: 30
|
Re: Just got a G9 need to know how to wire ignition switch to push pull switch ASAP!
The red is the hot and the tan goes to your ignition. The black/red is for the oil level sensor and the black is a ground. I hooked the key switch up in mine to were when the switch is activated, the red wire sends power to the tan and black/red wire. Not sure why the ground is ran to the factory switch, but i just left mine off. It worked fine without it.
|
01-24-2010, 07:53 PM | #3 |
Getting Wild
Join Date: Aug 2009
Posts: 89
|
Re: Just got a G9 need to know how to wire ignition switch to push pull switch ASAP!
Thanks JTC your awesome!!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Key ignition switch | Gas Club Car | |||
Ignition Switch | Big Block Talk! | |||
12v Radio with push/pull switch fried the wire! | Electric Club Car | |||
Ignition switch fir B/S 20 hp | Big Block Talk! | |||
New Ignition Switch | Gas EZGO |