Ezgo series cart no reverse

[Bray6092]

Ezgo series cart

Forward works but reverse doesn't

Not controller

In reverse solenoid clicks but does move
I can't switch s1 and s2 and will go in reverse

The f&r switch is brand new but in the lever in reverse position it doesn't go.

Help

[sthreatt]

The switch mounts to the floor in slotted holes to make it adjustable left and right. This allows for adjustment of the distance of travel of the handle to make sure it goes completely into connected position. Check to make sure it is centered in travel, and also make sure the levers on both ends of the rod are mounted properly, both pointed upward. For whatever reason, you're not making connection in reverse.

[Sir Nuke]

the fact that the f&r is new, did it start this when it was installed from the start? if so....the switch mounting holes are slotted.....you need the adjust it such that the both sets of contacts make connection. obviously the reverse contacts aren't making contact.