|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
10-21-2015, 10:48 PM
|
#1 |
|
Not Yet Wild
Join Date: Dec 2012
Posts: 16
|
G1: issues after rebuild and gov delete
Replaced the crank bearings and seals. Replaced piston rings and wrist pin bearing. Honed the cylinder. Got it back together and runs good except..........I removed the governor, including the butterfly in the exhaust outlet. Now once in a while it will pop back and blow the pulse hose for the fuel pump off at the block. Should the butterfly be left on????
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-22-2015, 08:20 PM
|
#2 |
|
Vegas modded 420
 Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: G1: issues after rebuild and gov delete
You have to seal those holes shut can't have exhaust leaks by motor, make sure you have no intake leaks also, try richening the idle mix more. That valve cuts noise more than anything else, some came without them and it is not needed.
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1984 Electric Club Car Rebuild (power issues) | Electric Club Car | |||
| electrical issues after carb rebuild | Gas EZGO | |||
Linear Mode
