Igniter ?

[virgilward]

Still fighting the issue of getting fire , coil checks out OK was getting spark a bit later checked and NO spark again could the Igniter be causing this ? Thanks

[jeffrun]

Typically i have found the ignitor works or completely dead. Poor output from a ignitor is either low voltage to coil or the black ground wire is not grounded good. Take loose the black wire from ignitor ,clean terminal and connect a jumper wire from it to the battery neg terminal,then try. If thats works,then terminate black wire to a good clean ground connection and check your battery cable grounds. When cranking,you should have around 12v on + of coil.

[virgilward]

Thanks for info I'll give that a try

[virgilward]

I checked the black wire on the ignitor for ground appears to be good , still no success any other suggestions ." Not Firing" :( Thanks