Looking for Wiring Diagram for YDRE with Factory Lightss

[Volt_Ampere]

I am starting work modifying my YDRE (2012) that has the factor lights installed and the wiring diagram that I have does not include the Lights and the voltage reducer. I have the round state of charge meter and it is powered even when the run/tow switch is in Tow. I need to add some stuff to the dash so I really want to know what the wiring looks like including the 12V stuff.

If anyone has a complete wiring diagram I would appreciate a copy!

[cgtech]

Yamaha does not provide wire diagrams for "accessories", your lights, while installed at the factory, are considered accessories. Thats the answer Yamaha gave me. Sorry man, SOL.

[Volt_Ampere]

Thanks for trying cgtech! I can figure it out - not that complicated. I think the reducer must be powered through the key switch since the lights don't work when the switch is off. The reducer wires are marked and easy to trace. I am adding some stuff to the dash that needs 12V. I am sure that I can find 12V somewhere there.

[kgsc]

Depends on the reducer but my new one gets the main 48 from the pack and has a trigger wire from the keyswitch. Less strain on the switch. My newest one that I haven't installed yet actually has a 12 volt constant as well. Not sure if it is a different circuit but provides a memory wire source for a radio. Going in the next build.

[smallblock450sl]

There should be an extra 12 volt lead taped up in the wire harness bundle about where it diverts down and the headlight leads. Useually with red tape.

[sodar]

Does anyone have a wiring diagram for the YDRE in general?

I'd like to kill the power to my voltage reducer when the key switch is off, but can't find anything unless I t-tap into the key switch wiring.

Is there any other way?