|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
05-10-2012, 09:33 PM | #1 |
Gone Wild
Join Date: Jan 2011
Location: Las Vegas, Nevada
Posts: 1,942
|
Pissy G2
So I pulled my engine cradle off a couple days ago and pulled the wiring harness complete. It ran perfectly fine when I pulled it into the garage. I had to replace the cross member. Got that all taken care off bolted it all back together but now it fires like an old hit and miss. Pulled the plug it's sparking strong every stroke, don't have my air cleaner on, pulled my carb apart thinking something might have crawled into and still nothing. I found my vent tube going to the fuel pump was split fixed that with a new hose still nothing. I'm thinking it's deffinetly fuel related either fuel pump is shot or there is dirt in the tank that got shifted when I pulled it off. The fuel pump is pumping gas but not sure it's pumping enough. How do I tell if my pump is pumping good or not? Any other suggestions?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-11-2012, 07:10 AM | #2 |
Gone Wild
Join Date: May 2011
Location: North East Tn.
Posts: 1,029
|
Re: Pissy G2
I don't know about the G-2 but my G-20 got to where it wouldn't run right. All I had to do was clean out the vacuum line from the crank case to the pump, just take it off the pump side and blow through it. Thats all it took to get mine running fine!!!!!1
|
05-11-2012, 07:43 PM | #4 |
Gone Wild
Join Date: Jan 2011
Location: Las Vegas, Nevada
Posts: 1,942
|
Re: Pissy G2
I pulled the pump, drained the tank cleaned them both thuroughly put clear lines on it so I can see the fuel flow rate. Same thing. Swapped to three different fuel pumps one stock replacement and one electric same thing. I assume now that the fuel is good and it's got to be something in the carb I missed.
|
05-11-2012, 08:21 PM | #5 |
Gone Wild
Join Date: Jun 2009
Location: ozarks
Posts: 237
|
Re: Pissy G2
did you remove the jet/orfaces and run a cutting torch cleaner through them?
|
05-11-2012, 08:39 PM | #6 |
Gone Wild
Join Date: Jan 2011
Location: Las Vegas, Nevada
Posts: 1,942
|
Re: Pissy G2
Yup. In fact my main jet is a CPP performance jet that isn't all that old. They are both shiny clean and flow nicely. I forgot to mention I can fire it up and use the seat to hold the gas peddle then I disconnect the wire for the starter/gen solinoid so it isn't turning the motor after fire up. It will sit and idle but very ruff. If I give it any gas it stumbles and dies.
|