|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
11-06-2014, 09:58 AM | #1 |
Not Yet Wild
Join Date: Nov 2014
Posts: 4
|
ydre rear axle grinding noise
My 2008 YDRE has a rhythmic speed sensitive grinding noise eminating from the rear end when the cart is moving (coast/float condition), but not under acceleration load. Replaced with fresh oil to no avail. Have removed motor, but see no problems at that interface.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-06-2014, 12:19 PM | #2 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,193
|
Re: ydre rear axle grinding noise
Sounds like a bad rear gear!
|
11-08-2014, 07:41 AM | #3 |
Gone Wild
Join Date: Sep 2013
Location: Jacksonville, Fl
Posts: 170
|
Re: ydre rear axle grinding noise
Could be the gears but they also get some play in the input shaft bushing. If you have the motor off, look inside the shaft and there is a little rubber bushing down in there. Pull it out, put 2 pennies in, then the bushing and a little bit of grease. Play is gone and possibly your growling will be too
|
11-08-2014, 12:21 PM | #4 |
Not Yet Wild
Join Date: Nov 2014
Posts: 4
|
Re: ydre rear axle grinding noise
I have bought the replacement bushing. Are the two pennies a good idea with a new bushing? Both spline ends show wear. I plan on replacing the input shaft also, as this is the cheaper component than the motor side.
Last edited by cedarriver; 11-08-2014 at 12:32 PM.. Reason: More detail |
11-08-2014, 02:27 PM | #5 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: ydre rear axle grinding noise
I would skip the pennies. The new bushing is actually sometimes too long. When you put the motor back on, if you have more than 1/8" gap between the motor and axle flange before you put the bolts on, the bushing will need trimmed. Do not trim from the end the taper is on, it needs the taper to center the input shaft and armature.
|
11-29-2014, 11:54 AM | #6 |
Not Yet Wild
Join Date: Nov 2014
Posts: 4
|
Re: ydre rear axle grinding noise
Replaced the input shaft to transaxle that had a worn spline, and inserted the new rubber bushing with high temperature grease. Everything is fine. The spline shaft on the motor was worn also, but that fix was too expensive. I'll see how long this fix works. Thanks for all the supporting posts.
|
08-04-2015, 08:30 AM | #7 |
Not Yet Wild
Join Date: Aug 2015
Posts: 1
|
Re: ydre rear axle grinding noise
Cam anyone provide the part number for the rubber bushing, or is it the grommet?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2008 RXV rear end differential oil change advise / noise / grinding | Electric EZGO | |||
Grinding noise from rear | Electric EZGO | |||
Grinding noise in rear | Gas Club Car | |||
Yamaha G9-Grinding noise left rear | Gas Yamaha | |||
grinding noise from rear | Electric Club Car |