Speed magnet installment😟

kokkos88 · 10-03-2019, 06:56 AM

Hey!
Shipped a FSIP tourqe motor over to me here in Norway, and the speed magnet was crushed. So ordered a new one, which I’m trying to install. The only problem is the srew that will hold the magnet in place. It sits really hard, and I scared of snapping it if I’m going the wrong way. Is it normal like “lefty loosy” or is it some special thing and I have to screw to the right to unscrew? In the picture you can see the screw.

NoleFan4Ever · 10-03-2019, 11:23 AM

You can try and contact FSIP to be sure or you can put a #2 Phillips on there and give it one good smack on the butt with a hammer. Then grip it tightly and turn it counter-clock wise first. If it does not break loose, then go clock wise. That screw should not break off as it is in a hardened shaft. Now if you gorilla grip it anything could happen, but you just want to apply the proper pressure to break it loose.

NoleFan4Ever · 10-03-2019, 11:37 AM

I just verified with FSIP. It is standard threads so turn it counter-clock wise to loosen it....

WalterM6 · 10-03-2019, 08:56 PM

Probably got loctite on it.

10-03-2019, 08:56 PM	#4
WalterM6 Gone Wild Join Date: Apr 2017 Location: SE TN Posts: 2,226	Re: Speed magnet installment😟 Probably got loctite on it.

Similar Threads
Thread	Forum
Speed Code & Hi-Speed Motor Magnet	Electric Club Car
High Speed Magnet or Speed Code 4???	Electric Club Car
Will Speed Code 4 work if a high speed magnet does not?	Electric Club Car
Speed Magnet	Electric Club Car
Spring Installment on 94 EzGo	Electric EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

10-03-2019, 11:23 AM	#2
NoleFan4Ever MOD of all BS! Join Date: Sep 2011 Location: Florida Posts: 17,477	Re: Speed magnet installment😟 You can try and contact FSIP to be sure or you can put a #2 Phillips on there and give it one good smack on the butt with a hammer. Then grip it tightly and turn it counter-clock wise first. If it does not break loose, then go clock wise. That screw should not break off as it is in a hardened shaft. Now if you gorilla grip it anything could happen, but you just want to apply the proper pressure to break it loose.