|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-05-2018, 11:31 PM | #1 |
Not Yet Wild
Join Date: Aug 2018
Posts: 2
|
alltrax xct 400 install under voltage code
I recently installed an alltrax xct 400 on my 2002 ezgo 36v. If I have the charger hooked up and unplug it and power everything up the green led light stays green but if it sets for a little bit the battery pack drops to the upper 38volt range and I power it up it will flash 1 green and 2 red and it won't move.
Sent from my SM-G950U using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-05-2018, 11:41 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: alltrax xct 400 install under voltage code
Sounds like something is draining the controller capacitors faster than the precharge resistor can replenish.
|
08-06-2018, 10:15 AM | #3 |
Not Yet Wild
Join Date: Aug 2018
Posts: 2
|
Re: alltrax xct 400 install under voltage code
could it be a bad battery?
Sent from my SM-G950U using Tapatalk |
08-06-2018, 11:24 AM | #4 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: alltrax xct 400 install under voltage code
Likely the under voltage value is set to 38v
Reset the under voltage value to 28v |
08-06-2018, 12:10 PM | #5 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: alltrax xct 400 install under voltage code
If the under voltage slider is set to 28V or so, check the voltage on J1 Pin-5. It ought to be exactly the same as the battery pack voltage.
Pin-5 is fed by the red wire from the solenoid's battery side large terminal that has the sonic weld that fails. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax AXE code 3 | Electric EZGO | |||
Alltrax DCX300 blink code low voltage & motor overheating | Electric Club Car | |||
Digital Volt Guage doesn't match pack voltage after Alltrax install | Electric EZGO | |||
Alltrax trouble code #2 | Electric EZGO | |||
Alltrax fault code 5 | Electric EZGO |