Two wires on the alltrax to go

[Hit it like a champ]

http://www.buggiesgonewild.com/attac...1&d=1533738660
Ok I have 2 wires to go and I think blue one goes to the positive and the black with white stripe goes to the negative of the battery but do I connect to the first battery or positive of the first and the negative of the last. The harness branches off to the tail lights. In the pictures I took I can see the blue one to the positive terminal I can see the black one but it gets lost in the picture. My cart is a 2014 precedent IQ. Thank you Jerryhttp://www.buggiesgonewild.com/attachment.php?attachmentid=173662&stc=1&d=1533739 460

[WalterM6]

Check your photos and diagrams and see if the black w/white stripe came off the B- connection on your old controller. If it did you can connect it back to B- or directly to the main battery negative.

[Hit it like a champ]

http://www.buggiesgonewild.com/attac...1&d=1533754473
If this is the one you mean I already hooked it up and I know it’s the same because of the writing on it. This is killing me one wire to go and I am almost positive it’s just a ground for the taillights. It might have bean tied into the negative that went to the ladt battery. I think I might have cut it and put a terminal on it. If so then there is some kind of voltage reducer on the tail lights. The cart has headlights also. Would they run them off of I 8v battery. I don’t think so. I think I am just going to try it on the last battery after work. Thank you for the help. Jerry

[Hit it like a champ]

http://www.buggiesgonewild.com/attac...1&d=1533763259
I can see that last terminal and that black and white striped wire it's not going to the last terminal. I would hate to have to take this thing somewhere just because of one wire. If I put 48v to it and it’s the tail lights and headlights it will fry them fore sure

[WalterM6]

You need to find out if you have a 48 to 12 volt reducer in your cart. I'm guessing you do. But I can't say for sure. If you had a 16 to 12 reducer that blue wire wouldn't be connected to the main battery positive.

[Hit it like a champ]

Originally Posted by WalterM6

You need to find out if you have a 48 to 12 volt reducer in your cart. I'm guessing you do. But I can't say for sure. If you had a 16 to 12 reducer that blue wire wouldn't be connected to the main battery positive.

Ok how do i find this out do you know the location of it. And thank you again i am pretty positive everything else is wired correctly. I did use the bigger cables good idea.

[WalterM6]

The only way for sure you are going to know where that black wire goes is to trace it back to see were the other end is connected. You might have to cut a few ty-wraps but it's easy to repair.

[Hit it like a champ]

Ok but i think it is a Madjax bucket harness. If so I i can try to do a search on installing that.

[WalterM6]

Here is a wiring diagram for a 2014. Notice on the lower right hand side that there is three connections on B-. One from the battery which is a heavy gauge. Another from the charging recpt which is a 10 ga and another 10 ga labeled ACC ground. You should have all of them attached.

[Hit it like a champ]

I found it its a 48v reducer and harness bucket harness that is it does go to the first and last battery. Thanks a lot man appreciate it