Need Help w/ Switched 12v

[wjerlinger]

On all vehicles (other than this) I've been able to pull a switched 12v from the ignition switch. For some reason I can't get the 12v from the ignition switch on the ezgo. Does anyone know where I should tap into to get a switch 12v?

My ignition wires are bule and green just like in this picture. Any ideas would be helpful. Thanks

[wslonger]

Ms3 turns the solenoid on when the accelerator is pressed and energizes the circuit there is no place to hook up a switched 12v from the key switch.
You could modify the wire as shown below to get a 12V switched source.

[scottyb]

Your diagram looks like a 99-2000 txt? THe key switch has a switched terminal. Actually 2 if you have the 3 way key with a light switch built in.

[wjerlinger]

Thanks for the replies...

wslonger - Thanks for the info and the diagram. I guess my only question is what is "MS3"?

scottyb - The back of my key switch has two terminals. One has a blue wire going to it and the other has a green wire. My problem is that neither wire has 12v and I was expecting that one of the wires would have a constant 12v and the voltage would carry to the other wire when the key is turned. Since this doesn't happen I can't find a switched 12v on my cart.

[wslonger]

MS3 is should be the micro switch at the accelerator