|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-10-2020, 01:10 PM | #11 |
Not Yet Wild
Join Date: May 2020
Location: Florida
Posts: 27
|
Re: No reverse after upgrade
This is how it’s wired the cable on top with the bar goes to motor A2 the cable on the bottom goes to controller B+
M1 goes to motor A1 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-10-2020, 03:20 PM | #12 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: No reverse after upgrade
That big + sign on the Top of the Contactor indicates it has magnetic blowouts installed and "polarity" needs to be observed.
You need to switch Your cables 3 and 4 around. So B+ cable connects to the Top bar across the two posts on the contactor. The A2 cable goes to the bottom terminal of the Contactor. The change above will cause the cart to run opposite than it is running now, so You may need to change the S1 and S2 cables to have the motor runs on the same direction as the FNR switch. If all terminals on the contactor are tight and it clicks in either direction, I can only think of two possibilities at this time. 1. The Reversing Contactor has failed in one side (hit the body with a hammer wood handle to see if contacts inside are stuck). 2. If You are running a wire from the Alltrax Blue terminal (reduced speed) to the reversing contactor "reverse side" coil, perhaps You have the reverse speed set to 0% the Controller (Unplug the Blue terminal from the Alltrax to test). |
06-10-2020, 04:21 PM | #13 |
Not Yet Wild
Join Date: May 2020
Location: Florida
Posts: 27
|
Re: No reverse after upgrade
I tried switching 3 and 4 and all that did was give me reverse and no forward so i unplugged the blue wire and it made no difference
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Forward/Reverse upgrade for PDS? | Electric EZGO | |||
Forward/Reverse switch upgrade | Gas EZGO | |||
Pause, sometimes nothing in reverse after upgrade | Electric EZGO | |||
No Reverse after wire upgrade | Electric EZGO | |||
48V Upgrade/Reverse Buzzer | Electric EZGO |