|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-31-2020, 06:05 PM | #11 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: DCS ITS - weird reading
Quote:
The two wires have expected continuity, but that is not what I was asking for. Unplug the 10-pin connector from the XCT controller and unplug both wires from the ITS sensor. Connect the Red test lead to the White wire and the Black test lead to the Black wire at the pedal box end of the wires. That will give you the Ohmic reading BETWEEN the two wires. If the reading is 10,000,000Ω or above, the controller is bad. |
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-31-2020, 07:48 PM | #12 |
Not Yet Wild
Join Date: Sep 2019
Location: Chicago
Posts: 13
|
Re: DCS ITS - weird reading
Ok, I did exactly what you've requested
10 pin harness is not connected to anything. Black and white are unplugged from the ITC. Red probe is on the white wire at the ITC end. Black probe is on the black wire at the ITC end. VM is set to Ohms. 0L |
02-01-2020, 11:57 AM | #13 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: DCS ITS - weird reading
Quote:
You've tried two different ITS sensors, one of them being new, so that pretty much eliminates the ITS sensor as the problem source. That leaves the controller, and you've verified there is pack voltage on pins 9 & 10 and the constant current source that feeds the ITS sensor is powered by one of those two pins, so the operational needs for the controller appear to have been met. That leaves an internal controller issue. Time to ask for a warranty replacement. |
|
05-18-2020, 12:50 PM | #14 |
Not Yet Wild
Join Date: Sep 2019
Location: Chicago
Posts: 13
|
Re: DCS ITS - weird reading
Just closing the loop on this one. Talked to Alltrax a couple weeks back and did an RMA return on the original controller I purchased. Got the new one last week. Got it hooked up and only had one wire backwards on the install. Cart is all up and running now.
Huge thank you to everyone that helped offer tests/checks/suggestions. |
05-18-2020, 01:15 PM | #15 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: DCS ITS - weird reading
Quote:
Thanks for the feedback. |
|
11-07-2023, 01:56 PM | #16 |
Not Yet Wild
Join Date: Oct 2023
Posts: 3
|
Re: DCS ITS - weird reading
I have this same exact issue. Any progress?
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Something is weird here | Gas Columbia ParCar | |||
Volt meter reading vs Alltrax monitor reading | Electric EZGO | |||
Something a bit weird............. | Gas EZGO | |||
This is Weird! | Electric EZGO |