2014 Yamaha G29 48v beeps

[Chris135]

Hello all!
I have a 2014 G29 that ran for a couple of weeks after I got it and then quit. After doing research here I replaced the controller with an alltrax (XCT-48400) from DnD, even if it wasn't the controller the alltrax will solve the problem of a speed code.
Now when the key is turned on the cart just beeps until the key is turned off (and the cart will not move). I am sure it is an error message of some type. I am currently charging the cart to be sure there is a full charge. After that where do I go next?

Batteries are fully charged

[cgtech]

I suggest hooking up your laptop to the controller to see what it says is wrong. The software to do it is free & it uses a "usb type a -to- usb type b" cable. Otherwise, your pretty much chasing your tail.

[Chris135]

More info:

Key off = I can plug into the controller with the software, no errors on software
Key on = the controller disconnects from the software like it was shut off and the LED on the controller stays off
Beeping has stopped
Checked both large terminals on the solenoid both read 50v - shouldn't one side be 0 with the key off?

Spoke with Alltrax - they suspect a possibly bad controller or harness

[cgtech]

I'm going with wire harness problem. But, at least the whole harness is only about $150.

I wouldnt buy a harness just yet tho.

Please give some screen shots of the controller software. I wanna make sure it's set properly for your cart.