92 carry all drive belt and starter belt

[sol hunting]

Any one have the NAPA drive and starter belt #'s for a 1992 Carryall. 1" wide by 37 3/8 Length is what I have come up with. Any help appreciated. Thanks SOL

[BLACK DEATH]

Now that info should be sticky if its not. I wonder if they used the same for my 90 & 99 cart?

[ckiguy]

sol get me a cc part number if theres one readable, i will check with a gates or goodbear deler and see if theres one available othere then from cc. if not if any one else has numbers i acn see what they have, if they have it.

[ckiguy]

hey from what i can find on those cc numbers a 92 has the geny belt as a 1014290 around 10 bucks. and the drive belt is around 27 dollars. with a cc number of 1016203 for the ohv engine, and 1017188 for the da engine. im assuming the flat head. if these are correct i will run these numbers and see what i can find.

[ckiguy]

1991 Club Car Carryall Kawasaki 1-Cyl. 286cc
Application Product Type Part # Comments
Belt Drive System

Front End Accessory Drive Components

Drive
Special Belt 6013
Gen.; W/33 1/8" Belt O.C.
High Capacity V-Belt (Standard) 7325
Gen.; W/37 5/8" Belt O.C.
High Capacity V-Belt (Standard) 7370

Information provided by Gates Automotive Product Application

Use our parts store locator to find thousands of locations where you can purchase Gates Automotive products.


Part Locator Toolbar

Print Format

[ckiguy]

here is the gates info. should be available at any napa, or they can also cross these over. hope this helps.

[sol hunting]

it is a ohv fe290 cc belt says it is 1" wide X 37 3/8 #1016203. What would be the best belt to use I have put clutch spring in and 200 idle spring a timing advanc key and carb jet with k&n air filter. Im not looking for high speed just good hill climbing ability at hunting camp. I have not done any milling on the clutch sheaves. I have heard people using different belt to accomplish different power to the ground. Thanks for the help!

[ckiguy]

i have heard of people using shorter belts for sped , but not for power, it engages the clutches sooner. from my understanding. for some reason i canat find a number on a gates fro a 92. or it wont cross over with the cc number. paitence plese!

[Deans]

Check out the Dayco site below... This chart is for ATV/snowmobiles and should also work just fine on your cart. Belts are available by size if you can't get a standard cross reference from the CC number. (no, I don't work for them!)

http://www.daycoproducts.com/daycowe...Dimensions.pdf

[ckiguy]

Sol I Dont Work For Gates Either, I Dont Even Use There Product Very Much, Just Know They Have A Good And Easy To Use Cross Refrence.