Precedent Front lights / front blinkers not working .... Where do I start looking?

[skymast]

I have an 09 Precedent with full light kit (lights, blinkers, horn, brake lights). Brake lights work, rear blinkers work, horn works, but the front lights and blinkers do not. Where should I start looking to trouble shoot this? Thx!

[scooterman]

Right behind the light up front is a 9 pin connector, start there. It is sorta tight but push it together to see if it was loose.

[skymast]

Checked that. That is fine. It seems to be a controller or fuse related issue.

[scooterman]

You need to test for voltage from the wiring harness, if your getting rear lights and not getting power to the front. There should be a connector under the dash panel, test there for your 12 volts then work your way back. Just because these connectors are made up doesn't mean they are good you have to test to make sure they are conducting, they are cheesy and easy to have loose connections internally, the pins don't always make up well and tend to push out. I'm assuming this because you have power to the back lights and they are all supplied from the same source and the front is completely dead from what your saying.

[skymast]

The lights and left blinker now work 'sometimes' so it's some type of gremlin!

[scooterman]

Sounds like a lose connection. The Molex connectors are famous for that. If you separate the connector on one end and look at the pins, there is a male side and a female side usually one of the pins pushed back in the socket or loose. If really bad I'll push it out and carefully bend the retainers back out so they can grip the socket when you push it back in.