driven clutch for 1988 ezgo

irene.jack · 12-03-2009, 07:35 PM

Can anyone tell me how the driven clutch comes apart after you get set screw out? Does it slid off or does it screw off? Thanks Jackie

ruredy · 12-06-2009, 08:17 AM

Drive Belt running from front to back......It's on a splined shaft and should slide off

scottyb · 12-06-2009, 09:27 AM

Quote:

Originally Posted by ruredy

Drive Belt running from front to back......It's on a splined shaft and should slide off

THere is a C ring on the transaxle side you remove the C-ring and she pops apart. It is under a bit of srping load

irene.jack · 12-09-2009, 06:19 PM

Guys,I figured it out ,what I needed to know was how to pull the driven clutch apart.After you get set screw out you need to put gear puller on clutch to pull it apart to replace spring,a 3 arm puller is what you need. I made a 3/8 spacer the od and id of stock spring,put spacer under spring,took a peice of 1/2 inch all thread about a foot long,put thur clutch assy.with 1/2 washers on each end then put 1/2 hex nuts on each end and tighten until clutch assy. was pulled by in place. Then reinstall set screw,ready to put back on cart. hope this helps someone along the way,if I can help you jusy let me know,Jackie

12-03-2009, 07:35 PM	#1
irene.jack Not Yet Wild Join Date: Sep 2008 Location: sanford,nc Posts: 36	driven clutch for 1988 ezgo Can anyone tell me how the driven clutch comes apart after you get set screw out? Does it slid off or does it screw off? Thanks Jackie

12-06-2009, 08:17 AM	#2
ruredy Born Wild Join Date: Mar 2007 Location: Clover SC. Posts: 5,552	Re: driven clutch for 1988 ezgo Drive Belt running from front to back......It's on a splined shaft and should slide off

12-09-2009, 06:19 PM	#4
irene.jack Not Yet Wild Join Date: Sep 2008 Location: sanford,nc Posts: 36	Re: driven clutch for 1988 ezgo Guys,I figured it out ,what I needed to know was how to pull the driven clutch apart.After you get set screw out you need to put gear puller on clutch to pull it apart to replace spring,a 3 arm puller is what you need. I made a 3/8 spacer the od and id of stock spring,put spacer under spring,took a peice of 1/2 inch all thread about a foot long,put thur clutch assy.with 1/2 washers on each end then put 1/2 hex nuts on each end and tighten until clutch assy. was pulled by in place. Then reinstall set screw,ready to put back on cart. hope this helps someone along the way,if I can help you jusy let me know,Jackie

Similar Threads
Thread	Forum
1988 Ezgo Driven (secondary) Clutch Problem	Gas EZGO
1988 EZ GO Driven Clutch	Gas EZGO
WTB EZGO Driven Clutch	Golf Carts and Parts
1988 gas ezgo secondery clutch	Golf Carts and Parts
ezgo driven clutch	Gas EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum