|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-31-2013, 09:57 AM | #1 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
48v conversion no power
I just did the 48 v conversion, 2 more batteries in the bag well, new HDTV 48v reversing contactor, new 48v solenoid, new diode for solenoid, 2 new diodes for reversing contactor, my problem is now I have now power to the controller
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-31-2013, 09:58 AM | #2 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
Re: 48v conversion no power
Sorry **** iPad correcting words. It's not HDTV it's heavy duty
|
03-31-2013, 07:29 PM | #3 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
Re: 48v conversion no power
Did some double checking and found a diode backwards on the solenoid and the main wire from the battery to the key switch blown fuse and blown reverse polarity resistor, but what would cause them to blow.......reverse diode on solenoid?
|
03-31-2013, 07:34 PM | #4 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 48v conversion no power
Are you asking about the marathon in your signature?
|
03-31-2013, 07:35 PM | #5 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
Re: 48v conversion no power
Yes. Finally did the 48v conversion
|
03-31-2013, 07:39 PM | #6 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 48v conversion no power
Can you post the diagram you used for the reversing contactor and controller install?
|
03-31-2013, 07:45 PM | #7 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
Re: 48v conversion no power
|
04-04-2013, 01:33 PM | #8 |
Not Yet Wild
Join Date: May 2011
Location: Sour Lake, Texas
Posts: 71
|
Re: 48v conversion no power
i think i found the problem...i had a diode reversed on the solenoid, and it let voltage feed back and blow the fuse....hope this was it
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G1 not starting...no power power coming from magneto? | Gas Yamaha | |||
What gives more power bigger controller or 48v conversion | Electric EZGO | |||
2005 Precedent starts of powered, then loses power, reverse always power | Electric Club Car | |||
Power Wise Charger worked after board replaced now back to no power | Electric EZGO | |||
92 Ezgo Resistor Conversion gone bad... HIGH AMP DRAW and Lack of power HELP!!!!! | Extreme DC! |