lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV.



Post New Thread  Reply
 
Thread Tools Display Modes
Old 02-09-2012, 08:37 PM   #1
hot rod
Getting Wild
 
Join Date: Dec 2011
Posts: 99
Default 88 2 cycle ezgo exhaust bolts

i have lost the bolts that attach the exhaust pipe to the motor. the pipe starts at the motor and ends at the muffler. everthing is okay but the bolts have fill out. i need to know what size bolts i need. it looks like there are 2.

hot rod
hot rod is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 02-10-2012, 02:01 AM   #2
walt-rate
Not Yet Wild
E-Z-GO
 
Join Date: Dec 2011
Location: Nokomis, FL
Posts: 63
Default Re: 88 2 cycle ezgo exhaust bolts

hot rod: the book says that they should be studs not bolts.
"stud exhaust port MB X 1.25/ 5/16+-18 UNC 2A"
and "nut, hex, 5/8-18"hope this helps..
you can take this info to the hardware store (Lowe's /home-depot/ace) they should get you the right stud or bolt if you want to use bolts..
walt-rate is offline   Reply With Quote
Old 02-10-2012, 10:18 AM   #3
hot rod
Getting Wild
 
Join Date: Dec 2011
Posts: 99
Default Re: 88 2 cycle ezgo exhaust bolts

thanks walt-rate you are right they are studs so mbx1.25/ 5/16+-18 unc 2a is the right stud for this. or is it 5/8-18" stud. how long is the stud?
hot rod is offline   Reply With Quote
Old 02-10-2012, 11:09 AM   #4
walt-rate
Not Yet Wild
E-Z-GO
 
Join Date: Dec 2011
Location: Nokomis, FL
Posts: 63
Default Re: 88 2 cycle ezgo exhaust bolts

If I 'm right the 5/16-18 is the stud, and the 5/8-18
is the nut side. if you use bolts I think the can only get 1.5" not the 1.25".. If you use the 1.5" bolt just add some washers on the out side. make sure you use locktite "blue"
walt-rate is offline   Reply With Quote
Old 02-12-2012, 11:13 AM   #5
cardiac
Not Yet Wild
E-Z-GO
 
Join Date: Oct 2011
Location: JC MO.
Posts: 11
Default Re: 88 2 cycle ezgo exhaust bolts

The nut will be the same size as the stud.
Yes, it's 5/16 x 18 stud and nut. the wrench size is 1/2" the two studs are 1.250 long.
cardiac is offline   Reply With Quote
Old 02-13-2012, 08:46 AM   #6
racin161
Gone Wild
 
Join Date: Feb 2011
Posts: 1,515
Default Re: 88 2 cycle ezgo exhaust bolts

Hot Rod just stand by I'm going to solve your problem today as I have a 85 2pg apart now and I'm going to get the studs today.I checked the bolts that were in the exh with a standard nut and they are metric so don't force a 5/16X18 stud in there I'll post after finding the correct studs. I'm not saying yours may be standard but just try to install a 5/16 course bolt by hand not wrench if it goes easy OK if not it's metric. Stay tuned!!!
racin161 is offline   Reply With Quote
Old 02-13-2012, 10:48 AM   #7
racin161
Gone Wild
 
Join Date: Feb 2011
Posts: 1,515
Default Re: 88 2 cycle ezgo exhaust bolts

Mystery solved The stud size is 8mmX1.25 and the length is1 1/4 long be sure to pickup some nuts while you there. Put a bit of blue loctite on the studs when installing then jum the stud with 2 nuts and secure in the cyl. When installing the pipe loosely fit it and start the nut with the least amount clearance pushing the pipe up as you go then install the other nut. (LOCK WASHERS RECOMMENDED) and your good to go. Hope it helps
racin161 is offline   Reply With Quote
Old 02-13-2012, 08:04 PM   #8
hot rod
Getting Wild
 
Join Date: Dec 2011
Posts: 99
Default Re: 88 2 cycle ezgo exhaust bolts

thanks to all who gave me advice it was 8m and 1 inch 1/2 long with washer and lock nut and i used loctite. running good will check in a couple days to make sure all is tight thanks again.
hot rod
hot rod is offline   Reply With Quote
Old 01-26-2013, 08:43 PM   #9
Blood River1
Not Yet Wild
E-Z-GO
 
Join Date: Jan 2013
Location: West Banks of Kentucky Lake
Posts: 27
Default Re: 88 2 cycle ezgo exhaust bolts

Found it!!
Blood River1 is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas EZGO


Thread Tools
Display Modes


Similar Threads
Thread Forum
88 EZGO exhaust Gas EZGO
Need Exhaust Manifold 98 EZGO Gas EZGO
Exhaust bolts/studs for a 83 EZGO? Gas golf carts
88 ezgo 2 cycle gas/oil mix coming out of exhaust Gas EZGO
295 ezgo exhaust Golf Carts and Parts


All times are GMT -5. The time now is 12:29 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. 2006-2017 Buggiesgonewild.com. All rights reserved.