|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
07-14-2009, 06:05 PM | #1 |
Not Yet Wild
Join Date: Jul 2009
Posts: 2
|
rebuild a G9 285CC YAMAHA
My Problem Is I Have A 285cc Yamaha And Rebuilding The Engine Was Apart When I Got It And I Am Trying To Figure Out The Timing, Crank Has A Dot On Small Gear And Then On The Big Gear On Crank 2 Teeth Has 86 Stamped, The Cam Does Not Have A Dot Or Mark Any Where Only A 1/4 Hole Through Gear And The Balancer Has A Dot On Gear Can Anyone Tell Me Where To Start With Cam And Balancer
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-14-2009, 06:33 PM | #2 |
Not Yet Wild
Join Date: Jun 2009
Posts: 5
|
Re: rebuild a G9 285CC YAMAHA
the big gear on the crank has a mark you line it up with the hole in the cam the balancer gear has a mark line it up with your other gear on the crank your piston will be at top dead center your balance shaft mark will be at around the 7 o'clock position your cam will be around 3:30 i just did a g8 hope this helps
|
07-14-2009, 06:51 PM | #3 |
Gone Wild
Join Date: Nov 2007
Posts: 469
|
Re: rebuild a G9 285CC YAMAHA
this pic should help
|
07-28-2014, 12:26 AM | #4 |
Not Yet Wild
Join Date: Oct 2013
Posts: 1
|
Re: rebuild a G9 285CC YAMAHA
thank you helped me very much
|
|
|
Similar Threads | ||||
Thread | Forum | |||
rebuild | Gas Yamaha | |||
G16 rebuild | Gas Yamaha | |||
86 rebuild | Gas EZGO | |||
244 rebuild | Gas EZGO |