Make 82 gas ezgo faster?

[aforsberg]

I want to make mine go faster, if it calls for losing some power that is ok, it is just a street and light dirt crusier.. Are their any kits for this year (82 gas ezgo) or any thing anyone has done that I could do? \

Thanks!

[scottyb]

You have a couple of options ..... bigger tires , more voltage, or both
You need to figure out what the actual condition of the battery pack is 1st....
Load test and/or hydrometer test.

[crash12888]

Originally Posted by aforsberg

I want to make mine go faster, if it calls for losing some power that is ok, it is just a street and light dirt crusier.. Are their any kits for this year (82 gas ezgo) or any thing anyone has done that I could do? \

Thanks!

Scotty, you started a little early today? thanks for the invite!! Now scoot over and save a stool for me.

aforsberg, you still have the gov hooked up?

[hawkeyedm2003]

Originally Posted by scottyb

You have a couple of options ..... bigger tires , more voltage, or both
You need to figure out what the actual condition of the battery pack is 1st....
Load test and/or hydrometer test.

We are talking a gasser here right?
Remove the cable to the govenor (at your own risk)

[aforsberg]

Haha. I think that actually might already be unhooked
Now that you say that, I realize I have been wondering what the cable dragging on the ground is suppose to do.

The cable dragging on the ground is goign from some little mechanism attached to the pulley on the left side of the cart.... then the otherside just drags to the ground.. if it was the goveneror wouldn't it go to the engine not the pulley

?

[aforsberg]

Its gas scotty

haha :D

[hawkeyedm2003]

Originally Posted by aforsberg

Haha. I think that actually might already be unhooked
Now that you say that, I realize I have been wondering what the cable dragging on the ground is suppose to do.

The cable dragging on the ground is goign from some little mechanism attached to the pulley on the left side of the cart.... then the otherside just drags to the ground.. if it was the goveneror wouldn't it go to the engine not the pulley

?

Mine is attached the carb (or was for that matter) and then goes over to a bracket near the driven clutch. When the driven clutch expands fully it was supposed to pull back on the carb throttle cable.

[aforsberg]

I got the same one you do.. Mines off... well, any ideas on how to make it faster and quieter? Those are my goals

[hawkeyedm2003]

Originally Posted by aforsberg

I got the same one you do.. Mines off... well, any ideas on how to make it faster and quieter? Those are my goals

Not really on either.

As far as quieter, good luck. I have been trying the same thing for a few months now. My campground doesn't like my noisy 2 stroke.
I have retro fitted a makeshift tailpipe with a lawn mower style muffler at the end of it. It really didn't quiet it so much as change the tone down a bit.

This is including the original muffler, so I basically have two mufflers on mine.

If you figure out how to make less noise, I'm all ears...so to speak.

[mb523]

Make sure all joints from the cylinder to the muffler are tight and the gaskets are good still. It is not uncommon to blow a gasket out where it comes out of the cylinder, which will make it very loud, even if it is a small break in the gasket.