|
07-24-2009, 06:01 PM
|
#1 |
|
Not Yet Wild
Join Date: Aug 2008
Posts: 11
|
EZ-GO Controller
I just purchased a new Alltrax DCX400 DCS controller. I was looking at the wiring diagram for the new controller. I am going to install a diode in across the relay coil. My DCS system did not have one. I assumed it was built into the controller. However, my old system has a resistor/diode pack across the power terminals of the relay. The new drawing indicates only a resistor. Should I remove the diode? Can anyone tell me what it is for? I think it is there to supress the voltage to keep arcing to a minimum and to keep from burning the contacts of the relay when the relay is de-energized. That is the only purpose I can think of. I just installed a new White Rogers 586 series relay that will handle the current.
ZOOM-T |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-24-2009, 08:33 PM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,402
|
Re: EZ-GO Controller
Your original controller and solenoid should have had a diode and a resistor cluster.... Foloow the Alltrax diagram to the letter. Hope this helps
|
|
|
|
07-24-2009, 10:46 PM
|
#3 | |
|
Not Yet Wild
Join Date: Aug 2008
Posts: 11
|
Re: EZ-GO Controller
Quote:
ZOOM-T |
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| a DC motor controller ( electronic speed controller) | Golf Carts and Parts | |||
| looking for controller | Electric EZGO | |||
| Need help with controller | Electric EZGO | |||
| Did lift kit cause controller to die? What are controller options? 95 EZGO 25864G05 | Electric EZGO | |||
| Need a pds controller | Golf Carts and Parts | |||
Linear Mode
