1993 electric club car

[lorin]

Originally Posted by Golferdave

Could be the micro Sw on the FRN Sw with 3 wires attached.
the speed signal to the controller goes thru the micro sw,,
one position is for Fwd, the other is for Rvs thru a resistor for slower speed

may have bad wire, connection or Sw contacts in the Fwd position

only has 2 wires but switch checks ok!

[Golferdave]

Does the solenoid click when in Fwd ?
Cart Serial # ?

[lorin]

Serial no. Of cart is a9332342056

[lorin]

Originally Posted by Golferdave

Does the solenoid click when in Fwd ?
Cart Serial # ?

yes, solenoid clicks when forward and pushing on pedal, but wont move!

Originally Posted by lorin

only has 2 wires but switch checks ok!

is there coils behind the batteries ?

like this but no solenoids

[lorin]

YES, I checked all those wires and they are all tight!

[lorin]

Originally Posted by lorin

YES, I checked all those wires and they are all tight!

still havent figured why it wont go forward, going to check micro switch in controller today!

[scottyb]

If the solenoid clicks in both F&R and the cables are good, check the F&R switch high amperage contacts. One simple test is to swap the 2 cables on the 2 F&R swivel terminals - if this reverses the problem replace the F&R .

[lorin]

Originally Posted by scottyb

If the solenoid clicks in both F&R and the cables are good, check the F&R switch high amperage contacts. One simple test is to swap the 2 cables on the 2 F&R swivel terminals - if this reverses the problem replace the F&R .

thanks, will give a try!

[lorin]

Originally Posted by scottyb

If the solenoid clicks in both F&R and the cables are good, check the F&R switch high amperage contacts. One simple test is to swap the 2 cables on the 2 F&R swivel terminals - if this reverses the problem replace the F&R .

switched the wires and when you put in reverse it goes forward, put in forward it wont move! going to order a new switch and replace it. thanks for the help!