lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Modified Golf Carts > Big Block Talk!
Big Block Talk! Everything about swapping a big block engine into your cart!



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-27-2007, 12:09 PM   #1
Xtreme Cartz
The Fabricator
 
Xtreme Cartz's Avatar
 
Join Date: Dec 2006
Posts: 2,015
Default Basic Wiring

I'm a bit rusty when it comes to making a wiring harness from scratch. I am getting ready to wire up my 27hp Kawasaki engine. I have a wiring diagram for the engine and understand most of it. But for all the other electrical accessories I don't know where to start. There will be the typical engine gauges, electric radiator fan, front and rear lights, etc. What's the basic rule of thumb to go by for sparking this stuff up? Should there be a fuse box grounded to the frame and then run all of this stuff to that? The workhorse has a fuse panel on it so maybe I can use that.
Xtreme Cartz is offline   Reply With Quote
 
Go Back   Buggies Gone Wild Golf Cart Forum > Modified Golf Carts > Big Block Talk!


Thread Tools
Display Modes



All times are GMT -5. The time now is 09:28 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2023, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. 2006-2017 Buggiesgonewild.com. All rights reserved.