2006 club car gas won't run

[Madera11]

Hi having problems with my cart getting it to run. I have replaced the Gcor module, the solenoid, and just looked at the starter brushes, they look fine. I have replaced the spark plug also. When I turn key on I get power motor will go to ideal mode but won't move or jump in to run. Any help would be appreciated.

[meimk]

Originally Posted by Madera11

Hi having problems with my cart getting it to run. I have replaced the Gcor module, the solenoid, and just looked at the starter brushes, they look fine. I have replaced the spark plug also. When I turn key on I get power motor will go to ideal mode but won't move or jump in to run. Any help would be appreciated.

So are you saying the starter cranks but the engine will not fire up and run? The three basics: compression, fuel & spark. Pull the spark plug & see if it "puffs" out the spark plug hole when you crank it over (compression). While you're at it hook the spark plug to the plug wire and touch the base to ground and see if it crates a spark when you crank it over (spark). If both of those seem ok pull the air intake hose and squirt a little starting fluid or carb cleaner spray into the carburetor intake then crank it (fuel).

[ericandrews331@msn.com]

Originally Posted by meimk

So are you saying the starter cranks but the engine will not fire up and run? The three basics: compression, fuel & spark. Pull the spark plug & see if it "puffs" out the spark plug hole when you crank it over (compression). While you're at it hook the spark plug to the plug wire and touch the base to ground and see if it crates a spark when you crank it over (spark). If both of those seem ok pull the air intake hose and squirt a little starting fluid or carb cleaner spray into the carburetor intake then crank it (fuel).

What he said spark air fuel . I always start with spark usually the issue

[Madera11]

Great tips I will let you know the results t his weekend. If there is no spark I am guessing I have to replace the ignition coil correct.

[meimk]

If there is no spark then you'll want to check ignition grounds and RPM limiter before you just throw money at a coil.

[Madera11]

Well I pulled the body apart. I bypassed the cap pushed a nail into the cable and I seem to occasionally get a very week spark. I am going to expose the. Coil ignition and the raps limiter. I'm almost thinking because I have it all accessible I can replace things anyways. Still open for any opinions on why the spark is so weak.

[Madera11]

Just an update , I decided to change out the coil and the limiter since I had the cart pulled apart anyways. Not sure exactly what one was the dead part. However once both new parts installed spark was strong and cart is now running.

Thanks for taking time to help out.

[BigBlockMan]

Was probably RPM limiter, Coil is more than likely still good. You may want to save it.