|
|
|||||||
| Electric Club Car Electric DS, and Precedent golf cars |
  |
|
|
Thread Tools | Display Modes |
11-26-2020, 06:01 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2020
Posts: 16
|
Keyway wearing out/falling out? Hub to crankshaft connection
I was doing a John Deere Gator electric conversion and transaxle had a three-quarter inch spline with 18 grooves and unfortunately I could not find anything that matched it that so I use this sprocket hub with the keyway however after running after about 15 minutes the key way is completely worn off or just falls out not sure which one,
Any ideas how I can connect that sprocket hub with the spline crankshaft assuming that the keyway is too weak given the torque of the john deere gator? |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
11-27-2020, 01:07 AM
|
#2 |
|
Gone Wild
 Join Date: Jan 2017
Location: Queensland Australia
Posts: 1,332
|
Re: Keyway wearing out/falling out? Hub to crankshaft connection
This is the electric club car forum. I suggest you post in the gas one.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G1 crankshaft keyway has cracks at corners | Gas Yamaha | |||
| Helix wearing out | Gas Yamaha | |||
| clutch wearing out | Gas Yamaha | |||
| Engine Keyway? | Big Block Talk! | |||
Linear Mode
