|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-25-2022, 07:52 PM | #1 |
Not Yet Wild
Join Date: Apr 2021
Posts: 54
|
MCOR IV Bad already?
A year ago (actually this weekend Memorial Day) we went camping and used the cart heavily. On the last day of climbing hills at Lake Lanier Ga, it quit.
Long story short the controller burned up. (96 DS with a modified Curtis) I replaced it with an Alltrax 500 amp and a new MCOR IV retrofit kit with David's help from Revolution Carts. (June 2020) Recently had an issue with no reverse and jerky throttle. Again David talked me through the F&R switch being bad, installed a HD one, reverse fixed. But the throttle is jerky and cuts out at 100% throttle and I get the Low Throttle Input Under Range error flag. Testing it my MM jumps around and loses signal at 100%. I did the pump the throttle trick and cleared the memory and it worked for one ride. So my question is less than a year old it's bad? It's the made in mexico one too. Hope this isn't an expensive reoccurring thing. Thanks for letting me vent. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-25-2022, 11:33 PM | #2 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,218
|
Re: MCOR IV Bad already?
I've found that the Auto-Cal in the software doesn't work very well. Use the "Absolute Throttle" setting. This is the setup for an IQ it should be the same for a DS
|
05-26-2022, 08:11 AM | #3 |
Not Yet Wild
Join Date: Apr 2021
Posts: 54
|
Re: MCOR IV Bad already?
Thanks for the reply, I'll try anything lol.
My cart is a series cart and haven't seen that screen but will look for it! |
05-26-2022, 12:28 PM | #4 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,218
|
Re: MCOR IV Bad already?
If I remember correctly you have to go into the throttle page and select it.
|
05-26-2022, 06:12 PM | #5 | |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: MCOR IV Bad already?
Quote:
See this: https://buggiesgonewild.com/showthread.php?t=175721 Just sayin'..... |
|
05-26-2022, 11:03 PM | #6 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,218
|
Re: MCOR IV Bad already?
And with a little bit of electronic repair experience, you can open the MCOR up and repair it. The biggest problem is not enough spring tension on the wiper arm. There is a sticky on how to do it.
|
05-27-2022, 10:17 AM | #7 |
Gone Wild
Join Date: Jan 2014
Location: Okatie, SC
Posts: 310
|
Re: MCOR IV Bad already?
There is a new Mcor available on the market called RTS from Red Hawk. See it on U=tube @ Waynes Golf carts. He swears by it.
|
05-27-2022, 05:28 PM | #8 | |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: MCOR IV Bad already?
Quote:
Then you can change the OEM MCOR4 every year or so very easily. |
|
05-30-2022, 03:09 PM | #9 |
Not Yet Wild
Join Date: Apr 2021
Posts: 54
|
Re: MCOR IV Bad already?
Thanks everyone!
Tom47- I did the conversion kit, that's how I got this MCOR I have now. |
05-30-2022, 05:23 PM | #10 |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: MCOR IV Bad already?
Remember: Sometimes OEM stands for Often Easy Maintenance. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Pre mcor to mcor wiring help needed | Electric Club Car | |||
MCOR 1 To MCOR 4 conversion | Electric Club Car | |||
Pre mcor to mcor conversion kit problems | Electric Club Car | |||
MCOR to MCOR 4 conversion | Electric Club Car | |||
Club Car MCOR II to MCOR 4 Upgrade - Removing Pivot Rod? | Electric Club Car |