|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
06-05-2013, 02:54 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2013
Posts: 13
|
ez go dcs no go
ok so im new to carts. im at work trying to figure out why this cart will not run. 1994-96? electric ezgo with the dcs system. i have the cart raised up did all the tests in the manual regarding eletronic speed control( DCS). the diagnostic sheet leads me the ITS may be faulty. but when you depress the pedal the tires will move a bit than stop. the solenoid was replaced thinking it was that problem any help or ideas. thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-05-2013, 03:09 PM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: ez go dcs no go
My guess is the solenoid does not click when you press the gas and the cart is trying to run on the precharge current. Check your solenoid activation circuit. You need + and - at the two small terminals of the solenoid to make it click before the cart will 'go'
|
|
|
|
|
06-05-2013, 03:54 PM
|
#3 |
|
Not Yet Wild
Join Date: May 2013
Posts: 13
|
Re: ez go dcs no go
with a ground hooked up solenoid gets super hot. like power is flowing all the time( even with key in oof position)
|
|
|
|
|
06-05-2013, 04:25 PM
|
#4 |
|
Not Yet Wild
Join Date: May 2013
Posts: 13
|
Re: ez go dcs no go
no click from the solenoid.
|
|
|
|
|
06-06-2013, 04:19 PM
|
#5 |
|
Not Yet Wild
Join Date: May 2013
Posts: 13
|
Re: ez go dcs no go
anyone have a photo of the soleniod lay out.
|
|
|
|
|
06-06-2013, 04:37 PM
|
#6 |
|
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: ez go dcs no go
Welcome to BGW
Here is one for a DCS with solenoid activation circuit traced. In a DCS cart, the controller activates the solenoid by applying B- to one side of solenoid coil via Pin-7. B+ is supplied to other side of solenoid coil via the Reed switch, Run/Tow switch, F/R switch and Key switch. From there, B+ is also supplied to Pin-6 on controller and MS-2 When throttle is pressed, MS-2 forwards B+ to Pin-5, telling controller to turn on Pin-7 (B-)  Quote: JohnnieB |
|
|
|
|
07-05-2013, 08:35 PM
|
#7 |
|
Gone Wild
Join Date: Dec 2010
Posts: 635
|
Re: ez go dcs no go
good info
|
|
|
|
|
|
||||||
|
|
Linear Mode
