|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-02-2014, 02:47 PM | #11 |
Not Yet Wild
Join Date: Nov 2014
Posts: 51
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
Great, I will try to get to this later today, I assume the cart will run better? Because it's getting to much fuel correct??
I was thinking about doing that h.e.i. conversion, but I want the cart to run rite before I attempt anything else. Thanks for the help. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-02-2014, 02:49 PM | #12 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
If it is getting too much fuel, it will run poorly.
Does this cart have a lift on it? That adds to the problem because of the way the float is installed in the carb. When the angle of the swing-arm increases, so does the angle at which the carb is mounted. Angling the carb that direction allows more fuel into the carb before the float can raise high enough to shut off flow. |
11-02-2014, 04:22 PM | #13 |
Not Yet Wild
Join Date: Nov 2014
Posts: 51
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
No lift, can I leave carb in cart, or do I have to pull carb off? Thanks.
|
11-02-2014, 04:25 PM | #14 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
I don't know if you can get to it in the cart. Probably easier to just pull it out.
|
11-02-2014, 04:38 PM | #15 |
Not Yet Wild
Join Date: Nov 2014
Posts: 51
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
Ok I'll pull it, dumb question, where do I put the hose your talking about? Over the vent?? Thanks.
|
11-02-2014, 04:40 PM | #16 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
No, put it on the fitting where the fuel supply comes into the carb.
|
11-02-2014, 04:55 PM | #17 |
Not Yet Wild
Join Date: Nov 2014
Posts: 51
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
Lol, that was obvious!! Just pulled carb, I'll keep you posted. Thanks again.
|
11-02-2014, 05:53 PM | #18 |
Not Yet Wild
Join Date: Aug 2012
Posts: 57
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
Move the throttle linkage to the other pivot point.
The one it is attached to now is/was for the auto oil injection set up. |
11-02-2014, 06:00 PM | #19 |
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
|
11-02-2014, 06:08 PM | #20 |
Not Yet Wild
Join Date: Aug 2012
Posts: 57
|
Re: 89 ezgo, 244cc robin 3pg, 1st (toy)cart issues.
Just trying remembering all the little things that popped up on mine, that being one of them. Another thing, make sure ALL the gas line connections are secured with hose clamps. That was another lesson learned the hard way.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1983 EZGO textron Robin Engine 244CC 2 stroking Pulsar timing issue | Gas EZGO | |||
robin 244cc did not much power | Gas EZGO | |||
robin 244cc | Gas EZGO | |||
1987 ezgo with a robin 244cc motor | Gas EZGO | |||
WTB robin 244cc in KY | Golf Carts and Parts |