|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
05-11-2014, 01:52 PM
|
#21 |
|
Getting Wild
Join Date: Mar 2013
Location: Tallassee,Alabama
Posts: 141
|
Re: G16 cam help
Pachanga the G16 is almost the same as my 14 . when you take the starter /gen off and the primary clutch to remove the motor do you have to have a lift to pull the motor or is it light enough to just lift out of the area below the seat ? How much does one of these motors weigh ? Doesn't look much more than a lawm mower motor when all the stuff is taken off it . Just asking cause I may pull mine and do a rebuild later.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-11-2014, 03:12 PM
|
#22 |
|
maintaining a low profile
 Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,314
|
Re: G16 cam help
It's not that heavy, but ya gotta think about your back. At least, I do. I've got a cheap 2 ton chain fall that is more than adequate...
|
|
|
|
|
05-12-2014, 01:45 AM
|
#23 |
|
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G16 cam help
I can do it myself, but i always have a buddy help. You need to manuver it , and not mess up the body/paint, without throwing out the back. I also bolt a short battery cable (short green g22e cable) across the holes for the starter bracket to use as a handle.
|
|
|
|
|
|
||||||
|
|
Linear Mode
