07-31-2009, 04:05 PM | #1 |
Not Yet Wild
Join Date: Jul 2009
Location: FORT WORTH
Posts: 42
|
Carb / governor
I just installed a new engine in my 97 EZ GO. Took out a 295CC and replaced it with same exact engine. With the cart in neutral the engine will rev up and the governor kicks in... My problem is when driving the cart it seems very slugish, and is not responsive when giving it the gas. My cart would run about 20 miles per hour with old engine, now only does about 8 to 10.
All linkage was kept the same throughout the swap... any ideas on how to get my torque and speed back up to what it was? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-31-2009, 05:20 PM | #2 |
It ain't gonna be easy.
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,480
|
Re: Carb / governor
Sounds like you need to double check your governor adjustment. Look in the tech thread for the correct procedure.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G2 governor question | Gas Yamaha | |||
88 ez go governor | Gas EZGO | |||
governor | Gas Club Car | |||
G1 Carb. jet on outside of carb ? What the Heck ? | Gas Yamaha | |||
Governor arm set up problems | Gas Club Car |