Club Car

[John25Jeff]

I have a 48v Club Car. The charger will not work on the cart that I have, but the charger will work on a different cart. I have checked the fusable link in the receptacle and also checked OBC fuse in the club car - still nothing. There are brand new batteries in the cart, so I don't believe that is the issue. Any other suggestions on why the cart won't charge will be very helpful. Thank you.

[Volt_Ampere]

What is the pack voltage - and check it at the charger plug.

try resetting the OBC

Resetting the Club Car On board computer - reset the OBC

To reset the OBC the following must be done in this order:

If no Tow/Run Switch then skip that step

• Key Switch to Off
• Forward/Reverse to Neutral
• Tow/Run Switch to Tow
• Disconnect the Battery NEGATIVE (–) wire from the Battery Minus terminal on the battery pack.
• Put the Tow/Run to Run
• Forward/Reverse Switch to Reverse
• Key Switch to On
• Press the throttle pedal down (hold it to the floor)

The reverse buzzer will sound and go off in about 30 seconds.
Leave the cart like that for 5 min to cause the OBC to reset.
After 5 min release the throttle pedal

To reconnect the OBC back into the system:
• Key Switch to Off
• Forward/Reverse Switch to Neutral
• Tow/Run switch to Tow
• Reconnect the Batt – wire to the battery minus
terminal on the battery pack.

plug in charger to see if it works

if charger does not come on try by passing OBC

to by pass OCB
DO AT YOUR OWN RISK.…do not attempt unless you are familiar with electricity and electronics!
There are two ways to force the charger to turn on regardless of the OBC.

The first method is to disconnect the cart’s gray wire at the fuse near the charger receptacle. Then using a jumper wire, connect the receptacle side of the fused connector to the cart’s negative battery terminal. This will energize the charger’s 48V relay. If the charger doesn’t come on, it could be bad connections, wiring or charger relay.

The second method is to open the charger and remove the 120V wires from the relay and jump these together. This totally bypasses the relay and the OBC wire.


(If charger comes on but the charger ammeter shows 0 amps, check the fuse at the charging receptacle under the clear plastic cover.)

Both of these methods should both be temporary measures for troubleshooting, or as an emergency method of charging the batteries when they have been discharged so far that the OBC will not charge them.

The OBC provides the optimum method of charging the cart’s batteries. If the OBC is bad, it should be replaced