wiring diagram for a 1996 ez go golf cart marathon non DCS

[mgolfcart]

I'm looking for a complete wiring diagram for a 1996 ez go golf cart non DCS

[Sir Nuke]

http://www.buggiesgonewild.com/elect...g-manuals.html

[JohnnieB]

If it is a 1996, it is most likely a Medalist rather than a Marathon.
Here are schematics with and without the reed switch, it should be one of them.

[mgolfcart]

Thanks, I meant to say Medalist

[mgolfcart]

I ran a diagnostic test for a Non DCS Solid State Speed Controller and the ITS, everything checked out OK except for the problem I had to begin with. No power! Unless I jumped a wire from the pos side on the battery to the terminal on the solenoid were the red wire goes to, without that there is no power for it to run. But it dose run when I jump that wire. Is that the controller or the solenoid that has gone bad?

[JohnnieB]

Originally Posted by mgolfcart

I ran a diagnostic test for a Non DCS Solid State Speed Controller and the ITS, everything checked out OK except for the problem I had to begin with. No power! Unless I jumped a wire from the pos side on the battery to the terminal on the solenoid were the red wire goes to, without that there is no power for it to run. But it dose run when I jump that wire. Is that the controller or the solenoid that has gone bad?

Neither. You said the cart ran when you connected the battery positive the the red wire on the solenoid, so both the solenoid and the controller are good.

The problem is one of three or four switches in the solenoid activation circuit.
That circuit is highlighted on attached schematic.

[mgolfcart]

Thanks JohnnieB I think it might be a bad interlock, all the other points checked out I will open that box up and cheek the interlock