|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-29-2011, 08:11 PM | #1 |
Gone Wild
Join Date: Apr 2010
Location: West Tennessee
Posts: 1,271
|
Double Trouble ( NO GO )????
Ok now I have bought another 1986 resistor cart and it will go and quit go and quit, batterys are good also load tested and good batteries. Checked wiring again and its ok, all solenoids appear to be clicking and sometimes nothing and sometimes it will run and then just quit. Looked at acclerator because it is so loose in floorboard but didnt find anything there.
The F&R switch is so easy to go from forward to reverse its like its not making contact? If I stomp the pedal real fast all way to floor it will come on and quit like there is a short? I refuse to buy another resistor cart, LOL |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-29-2011, 08:39 PM | #2 |
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: Double Trouble ( NO GO )????
try riding around with your hand on the lever with pressure one way or another see if you make it act up....................................
|
07-05-2011, 11:52 AM | #3 |
Gone Wild
Join Date: Apr 2010
Location: West Tennessee
Posts: 1,271
|
Re: Double Trouble ( NO GO )????
Got it running after finding the wire from the F/R switch that goes to the last solenoid was very loose in the eyelet. Took apart and put on new ends and it runs. Still wont go until second click, so I am going to put some solenoids on it or switch a few around to try and narrow that problem down.
|
07-05-2011, 12:12 PM | #4 | |
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: Double Trouble ( NO GO )????
Quote:
......................................... |
|
07-07-2011, 04:31 PM | #5 |
Gone Wild
Join Date: Apr 2010
Location: West Tennessee
Posts: 1,271
|
Re: Double Trouble ( NO GO )????
I think the resistors are on backwards? which way does the electricity go from passenger to drivers side or vice versa? I have 2 carts here and they both have coils in different so I am confused
|
07-07-2011, 05:07 PM | #6 |
Gone Wild
Join Date: Jul 2009
Location: East Texas
Posts: 313
|
Re: Double Trouble ( NO GO )????
Ok your cart is not supposed to move until the second click. That part sounds normal to me. If everything is working correctly, it will start moving on the second click and then gets progressively faster with each additional click. 5 clicks total, but only movement on the last 4 clicks.
|
07-07-2011, 05:25 PM | #7 |
Gone Wild
Join Date: Apr 2010
Location: West Tennessee
Posts: 1,271
|
Re: Double Trouble ( NO GO )????
Ok I only have 4 clicks total and 1st click nothing, 2nd click starts to move, 3rd click same speed, 4th click faster, and thats it. I have replaced from drivers side to passenger side the 1st 3 solenoids and cleaned all coils, however not sure which one goes where? I would think that the 1st speed coil would start on the 2nd solenoid and continue in that order? Came to me unassembled and I have all new parts just needed a picture of what coil went where.
Thanks for the reply!! |
07-07-2011, 05:37 PM | #8 | |
Gone Wild
Join Date: Jul 2009
Location: East Texas
Posts: 313
|
Re: Double Trouble ( NO GO )????
Quote:
|
|
07-07-2011, 06:05 PM | #9 |
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: Double Trouble ( NO GO )????
to add coils go from left to right.......thinnest coil with the most loops 1st than they get a little thicker and less loops as you go to the right.............................
|
07-07-2011, 11:23 PM | #10 |
Gone Wild
Join Date: Apr 2010
Location: West Tennessee
Posts: 1,271
|
Re: Double Trouble ( NO GO )????
Thanks guys!! I finally got it figured out. The coils that were on it were not right. replaced the 3 coils with new ones, and found 1 microswitch bad in speed box, also took off z shape coil brackets and wire brushed back to metal so it would make good contact. All I can say is you learn something new every day
Great Site! Thanks again for all your help. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Double Project | Members Rides | |||
g9 double a-arm lift kit (has anyone tried one) | Gas Yamaha | |||
Someone double check me PLEASE | Electric EZGO | |||
Double Lift? | Design Center |